|
The E-ZPass® tag must be mounted properly before use.
If the tag is not properly mounted, it may not work and may be unlawfully
positioned.
- Clean placement area on inside of windshield with isopropyl (rubbing alcohol) and allow to dry.
- Remove plastic tape from back of Velcro™ mounting strips on tags.
- Position tag as illustrated below based on your mirror type.
- Press tags firmly against the windshield glass.
For vehicles, please mount tag as shown below:
Click for larger view (opens in a new window)
For motorcycles, please mount tag as shown below:
Click for larger view (opens in a new window)
For External tags and Commercial Trucks
Your external tag is designed to be attached to the front of your vehicle, on a
flat surface. It is screw-mounted in the area on the front bumper where the license plate
is located.
Position the tag so that the mounting holes correspond to
the top of the license plate area on the front bumper of the vehicle.
If the license plate area on your vehicle is partially obstructed
by an overhanging bumper, please call the E-ZPass® Customer Service Center at 1-800-333-TOLL(8655)
for an alternate mounting location.
Security Mounting
Tamper-resistant mounting screws may be provided upon request.
Step 1: Remove top two screws from license plate.
Step 2: Position tag so the mounting holes in the tags correspond to the
top holes in the license plate area on the front bumper of the vehicle.
Step 3: Tighten tamper-resistant screws provided with the unique Allen wrench to secure
tag to vehicle.
Mounting holes indicate top of tag for
upright mounting.
| 
